Cisco 7600 SPA-1X10GE-L-V2 SPA Card 1-Port 10GE LAN-PHY Shared Port Adapter SPA-1X10GE-L-V2 Overview The Cisco SPA-1X10GE-L-V2 is available on high-end Cisco routing platforms, offering the benefits of network scalability with lower initial costs and ease of upgrades. The Cisco SPA portfolio continues the companys focus on investment protection along with consistent feature support, broad interface availability, and the latest technology. The Cisco SPA portfolio allows deployment of different interfaces (packet over SONET/SDH [POS], ATM, Ethernet, etc.) on the same interface processor.This SPA-1X10GE-L-V2 is similar with the SPA-1X10GE-L-V2=. The SPA-1X10GE-L-V2= is a spare one. SPA-1X10GE-L-V2 Specification SPA-1X10GE-L-V2 SpecificationsProduct Compatibility Cisco Catalyst 6500 Series Switches Cisco 7600 Series Routers Cisco 12000 Series Routers Cisco XR 12000 Series Routers Cisco ASR 1000 Series Router Cisco CRS Carrier Routing System Cisco 10000 Series RouterPort Density per SPAOne 10 Gigabit Ethernet portPhysical Interface10-Gbps XFP opticsLED IndicatorsSPA status-Bicolor green and amber LEDs encode the SPA status as follows: LED off-SPA is powered off LED amber-SPA is powered on and initializing LED green-SPA is powered on and operationalIn addition to the status LED, the SPAs also have a bicolor LED dedicated to each port to indicate port status. The green and amber LEDs encode the port status as follows: LED off-Port is not activated by software LED amber-Port is activated by software, but there is a problem with the Ethernet link LED green-Port is activated by software, and there is a valid Ethernet linkFeatures and Functions Full-duplex operation 802.1Q VLAN termination 802.1ad QinQ termination (stacked VLAN processing) Jumbo frames support (9188 bytes) Support for command-line interface (CLI)-controlled online insertion and removal (OIR) 802.3x flow control Bridge protocol data unit (BPDU), Cisco Discovery Protocoland VLAN Trunking Protocol (VTP) filtering Layer 2 Protocol (BPDU, Cisco Discovery Protocol, and VTP) Tunneling Layer 2 access list (MAC address-based filtering) Up to 8000 VLANs per SPA and subject to a limit of 4000 VLANs per port for 802.1q Up to 5000 MAC accounting entries per SPA (source MAC accounting on the ingress, and destination MAC accounting on the egress) Up to 2000 MAC address entries for destination MAC address filtering per SPA, and up to 1000 MAC address filtering entries per port Per-port byte and packet counters for policy drops, oversubscription drops, cyclic-redundancy-check (CRC) error drops, packet sizes, and unicast, multicast, and broadcast packets Per-VLAN byte and packet counters for policy drops, oversubscription drops, and unicast, multicast, and broadcast packets Per-port byte counters for good bytes and dropped bytesOther software features supported: Ethernet over Multiprotocol Label Switching (EoMPLS) QoS Hot Standby Router Protocol (HSRP) Virtual Router Redundancy Protocol (VRRP)Reliability and AvailabilityOIR of the SPA within the SIP and the optics within the SPANetwork ManagementNetwork management: Field-replaceable XFP modules Host-system CLI Simple Network Management Protocol (SNMP)Inventory- and asset management-related MIBs: Entity-MIB (RFC 2737) Cisco-entity-asset-MIBFault management: Cisco-entity-field-replaceable unit (FRU)-control-MIB Cisco-entity-alarm-MIB Cisco-entity-sensor-MIBPhysical interface management: IF-MIB Etherlike-MIB (RFC 2665)Other MIBs: Remote Monitoring (RMON)-MIB (RFC 1757) Cisco-class-based-QoS-MIB MPLS-related MIBs Ethernet MIB/RMONPhysical Specifications Weight: 0.75 lb (0.34 kg) Height: 0.8 in. (2.03 cm) (single height) Width: 6.75 in. (17.15 cm) Depth: 7.28 in. (18.49 cm)Power19.9WEnvironmental Specifications Storage temperature: -38 to 150F (-40 to 70C) Operating temperature, nominal: 32 to 104F (0 to 40C) Operating temperature, short term: 32 to 131F (0 to 55C) Storage relative humidity: 5 to 95% relative humidity Operating humidity, nominal: 5 to 85% relative humidity Operating humidity, short term: 5 to 90% relative humidity Operating altitude: -60 to 4000 metersCompliance and Agency ApprovalsSafety UL 60950-1 CSA C22 No. 60950-1 EN 60950-1 IEC 60950-1 AS/NZS 60950 EN 60825-1 EN 60825-2 21 CRF 1040EMC CFR 47, FCC Part 15-Class A ICES 003-Class A CISPR 22 Class A EN 55022 Class A EN 300386 Class A AS/NZS Class A VCCI-Class B EN 50082-1 EN 55024 IEC/EN61000-4-2 Electrostatic Discharge Immunity (8-kV contact, 15-kV air) IEC/EN61000-4-3 Radiated Immunity (10 V/m) IEC/EN61000-4-4 Electrical Fast Transient Immunity (2-kV power, 1-kV signal) IEC/EN61000-4-5 Surge AC Port (4-kV CM, 2-kV DM) IEC/EN61000-4-5 Surge Signal Port (1-kV indoor, 2-kV outdoor) IEC/EN61000-4-5 Surge DC Port (1 kV) IEC/EN61000-4-6 Immunity to Conducted Disturbances (10 Vrms) IEC/EN61000-4-8 Power Frequency Magnetic Field Immunity (30 A/m) IEC/EN61000-4-11 Voltage Dips, Short Interruptions, and Voltage VariationsTelecom IEEE 802.3ae (10 Gigabit Ethernet interface SPA)Industry StandardsThe Cisco 1-Port 10-GE SPA is designed to meet the following requirements (some qualifications are currently in progress): SR-3580-Network Equipment Building Standards (NEBS): Criteria levels (Level 3 compliant) GR-63-CORE-NEBS: Physical protection GR-1089-CORE-NEBS EMC and safety Related Products HWIC-1ADSL-M HWIC-2FE HWIC-2SHESL HWIC-4T1/E1 ISM-VPN-29 VWIC3-1MFT-T1/E1 VWIC3-2MFT-G703 VWIC3-2MFT-T1/E1 EHWIC -1GE - SFP - CU PVDM2-ADPTR SPA-1XCHSTM1/OC3 HWIC-3G-HSPA-G SPA-8X1FE-TX-V2 SPA-2XCHOC12/DS0 SPA-4XOC3-POS-V2SPA-OC192POS-XFP SPA-2XT3/E3 SPA-4XT3/E3 SPA-8XCHT1/E1 SPA-1XCHOC48/DS3 SPA-8XOC3-POS
