AIR-PWRINJ1500-2 Cisco Power Supply 1520 Series Power Injector with AC 100-240 V 1.Overview When a Cisco Aironet 1520 Series access point is installed on the roof of a building, power can be supplied over Ethernet using a power injector. The power injector converts AC power into DC power and sends it along with the Ethernet signal to the access point. Use the Cisco Aironet 1520 Series Power Injector, along with any standard outdoor rated Ethernet cable, to power the access point. Do not use any power injector other than the onespecified. You will need to specify the country-specific power cord with the power injector. 2. Specifications Input voltage 100 to 240 VAC Output voltage 56.0 VDC Voltage range tolerance 54 VDC to 57 VDC Maximum current 1.43 A No load current 15 mA Output 1 voltage and current 56VDC@0.71A Pin 3, 6+56VDC Pin 1, 2Return Output 2 voltage and current 56VDC@0.71A Pin 4, 5+56VDC Pin 7, 8Return Operating temperature -40 to 131 degrees F (-40 to 55 degrees C) Storage temperature -58 to 185 degrees F (-50 to 85 degrees C) Operating humidity 10% to 90% non-condensing Storage humidity 10% to 95% non-condensing Length 8 in.(20.3 cm) Width 4.25 in.(10.8 cm) Height 2.5 in. (6.3 cm) Shows Power Injector Connections 1 Mounting tabs 4 AC POWER LED 2 AP POWER LED 5 TO APRJ-45 connection to access point (10/100/1000Base-T) 3 FAULT LED 6 TO SWITCHRJ-45 connection to switch (10/100/1000Base-T) Unpacking the Power Injector The following items are shipped with the power injector: A power injector An AC line cord This guide
