S5730-48C-SI-AC Huawei Network Switch 24 x Ethernet 10/100/1,000 ports, 8 x 10 Gig SFP+ Overview S5730-48C-SI-AC is a Huawei S5730-48C-SI Bundle, providing 24 x Ethernet 10/100/1,000 ports, 8 x 10 Gig SFP+, with 1 interface slot, and 150W AC power supply. Huawei S5730-SI series switches are next-generation standard gigabit Layer 3 Ethernet switches that provide flexible full gigabit access and cost-effective fixed GE ports and 10 GE uplink ports, meanwhile can provide 40 GE uplink ports with an interface card. The S5730-SI was developed based on next-generation high-performing hardware and the Huawei Versatile Routing Platform (VRP). The S5730-SI supports simplified Operations and Maintenance (OM), intelligent Stack (iStack), flexible Ethernet networking. It also provides enhanced Layer 3 features and mature IPv6 features. The S5730-SI can be used as an access or aggregation switch on a campus network or as an access switch in a data center. Specification S5730-48C-SI-AC Specification Ports 24 x Ethernet 10/100/1,000 ports, 8 x 10 Gig SFP+ Slots One extended slot that supports an interface card: 4 x 40 GE QSFP+ interface card Power Supply Dual pluggable AC or DC power supplies, one 150W AC power supply equipped by default Forwarding performance 240 Mpps Switching capacity 680 Gbit/s Memory (RAM) 1 GB Flash 512 MB in total. To view the available flash memory size, run the display version command. Mean time between failures (MTBF) 47.83 years Mean time to repair (MTTR) 2 hours Availability gt, 0.99999 Service port surge protection Common mode: plusmn,7 kV Power supply surge protection Using AC power modules: plusmn,6 kV in differential mode, plusmn,6 kV in common mode Using DC power modules: plusmn,1 kV in differential mode, plusmn,2 kV in common mode Dimensions (W x D x H) 442.0 mm x 420.0 mm x 44.4 mm (17.4 in. x 16.5 in. x 1.75 in.) Stack ports Any 10GE SFP+ or 40GE QSFP+ ports Ports on the 2-port QSFP+ rear stack card RTC Supported RPS Not supported PoE Not supported Rated voltage range 100 V AC to 240 V AC, 50/60 Hz -48 V DC to -60 V DC Maximum voltage range 90 V AC to 264 V AC, 47 Hz to 63 Hz -36 V DC to -72 V DC Maximum power consumption (100% throughput, full speed of fans) 62.4 W (without card) Typical power consumption (30% of traffic load) Tested according to ATIS standard EEE enabled No PoE power consumption 39.02 W (without card) Operating temperature 0C to 45C (32F to 113F) at an altitude of 0-1800 m (0-5906 ft.) NOTE: When the altitude is 1800-5000 m (5906-16404 ft.), the highest operating temperature reduces by 1C (1.8F) every time the altitude increases by 220 m (722 ft.). The operating temperature of the switch is 0C to 40C (32F to 104F) when it uses QSFP+ optical modules with 10 km or longer transmission distances. Short-term operating temperature -5C to +50C (23F to 122F) at an altitude of 0-1800 m (0-5906 ft.) NOTE: When the altitude is 1800-5000 m (5906-16404 ft.), the highest operating temperature reduces by 1C (1.8F) every time the altitude increases by 220 m (722 ft.). The equipment can operate beyond the normal operating temperature range for a short-term period, but the following conditions must be met: The equipment operates at a temperature of over 45C (113F) consecutively for at most 96 hours in one year. The equipment operates at a temperature of over 45C (113F) for a total of no more than 360 hours in one year. The equipment operates at a temperature of over 45C (113F) for no more in 15 times in one year. The equipment may be damaged or experience unexpected exceptions if any of the preceding limits is exceeded. The equipment cannot start when the temperature is lower than 0C (32F). The maximum distance of optical modules used in these conditions cannot exceed 10 km. Storage temperature -40C to +70C (-40F to +158F) Noise under normal temperature (27C, sound power) lt, 59.4 dB(A) Relative humidity 5% to 95%, noncondensing Operating altitude AC power modules configured: 0-5000 m (0-16404 ft.) DC power modules configured: 0-2000 m (0-6562 ft.) Certification EMC certification Safety certification Manufacturing certification The Optical Modules shows the recommended optical modules. Model Description eSFP-GE-SX-MM850 Optical Transceiver, eSFP, GE, Multi-mode Module (850nm,0.5km, LC) SFP-GE-LX-SM1310 Optical Transceiver, eSFP, GE, Single-mode Module (1310nm,10km, LC) S-SFP-GE-LH40-SM1310 Optical Transceiver, eSFP, GE, Single-mode Module (1310nm,40km, LC) S-SFP-GE-LH40-SM1550 Optical Transceiver, eSFP, GE, Single-mode Module (1550nm,40km, LC) S-SFP-GE-LH80-SM1550 Optical Transceiver, eSFP, GE, Single-mode Module (1550nm,80km, LC) eSFP-GE-ZX100-SM1550 eSFP, GE, Single-mode Module (1550nm,100km, LC) SFP-1000BaseT 1000BASE-T (RJ45) SFP Electrical Module, Auto Negotiate,100m SFP-10G-USR 10GBase-USR Optical Transceiver, SFP+, 10G, Multi-mode Module (850nm,0.1km, LC) OSXD22N00 Optical Transceiver, SFP+, 10G, Multi-mode Module (1310nm,0.22km, LC, LRM) OMXD30000 Huawei Optical Transceiver OMXD30000, SFP+,10G, Multi-mode Module (850nm,0.3km, LC) SFP-10G-iLR Optical Transceiver, SFP+,9.8G, Single-mode Module (1310nm,1.4km, LC) OSX010000 Optical Transceiver, SFP+,10G, Single-mode Module (1310nm,10km, LC) OSX040N01 SFP+, 10G, Single-mode Module (1550nm,40km, LC) SFP-10G-ER-1310 Optical Transceiver, SFP+,10G, Single-mode Module (1310nm,40km, LC) SFP-10G-CU3M Huawei SFP+,10G, High Speed Direct-attach Cables,3m, SFP+20M, CC2P0.254B(S), SFP+20M, Used indoor
