Huawei Switch S5730-36C-HI 24*10/100/1000BASE-T, 4*10GE SFP+,1 expansion slot S5730-36C-HI Overview Huawei S5730-HI gigabit Ethernet switches (hereinafter referred to as the S5730-HI) are Huawei-developed next-generation agile switches that provide fixed full gigabit access and 10 GE uplink interfaces as well as one or two slots for uplink interface extension. S5730-36C-HI Specification Item S5730-36C-HI Fixed Ports 24 x 10/100/1,000 Base-T ports, 4 x 10 GE SFP+ ports Dimensions (W x D x H) 442 mm x 420 mm x 44.4 mm Extended Slots One extended slot, supporting 8-port 10 GE electrical, 8-port 10 GE optical, or 2-port 40 GE optical interface card Input Voltage AC: Rated AC voltage: 100V to 240V, 50/60 Hz Max. AC voltage: 90V to 264V, 47 Hz to 63 Hz DC: Rated DC voltage: -48V to -60V Max. DC voltage: -38.4V to -72V Maximum Power Consumption (without cards) 74W Operating Temperature 0m to 1,800m altitude: 0C to 45C 1,800m to 5,000m altitude: The operating temperature reduces by 1C for each 220m increase in altitude. Relative Humidity 5% to 95% (non-condensing) Heat Dissipation Air cooling heat dissipation, intelligent speed adjustment, and pluggable fans 1 Twenty-four 10/100/1000BASE-T ports 2 Four 10GE SFP+ ports Applicable modules and cables: GE optical module GE-CWDM optical module GE-DWDM optical module GE copper module 10GE SFP+ optical module 10GE-CWDM optical module 10GE-DWDM optical module 1 m, 3 m, 5 m, and 10 m SFP+ high-speed copper cables 3 m and 10 m AOC cables 0.5 m and 1.5 m SFP+ dedicated stack copper cables (used for zero-configuration stacking) 3 One ETH management port 4 PNP button NOTICE: To restore the factory settings and reset the switch, hold down the button for at least 6 seconds. To reset the switch, press the button. Resetting the switch will cause service interruption. Exercise caution when you press the PNP button. 5 One console port 6 One USB port 7 Ground screw NOTE: It is used with a ground cable. 8 ESN label NOTE: You can draw it out to view the ESN and MAC address of the switch. 9 SSD card slot NOTE: Pluggable SSD card supported: SSD-240GB 10 Rear card slot NOTE: Cards supported: ES5D21Q02Q00 ES5D21X08T00 ES5D21X08S00 11 Fan slot NOTE: Applicable fan module: FAN-028A-B 12 Power module slot 2 NOTE: Applicable power modules: 150 W AC power module 150 W DC power module 13 Power module slot 1 NOTE: Applicable power modules: 150 W AC power module 150 W DC power module - - Service features Item Description MAC Address Table IEEE 802.1d standards compliance 256K MAC address entries MAC address learning and aging Static, dynamic, and blackhole MAC address entries Packet filtering based on source MAC addresses VLAN 4094 VLANs Guest VLAN and voice VLAN GVRP MUX VLAN VLAN assignment based on MAC addresses, protocols, IP subnets, policies, and ports VLAN mapping Wireless Service AP access control, AP domain management, and AP configuration template management Radio band management, unified static configuration, and dynamic centralized management WLAN basic services, QoS, security, and user management CAPWAP, tag/terminal location, and spectrum analysis Ethernet Loop Protection RRPP ring topology and RRPP multi-instance Smart Link tree topology and Smart Link multi-instance, providing millisecond-level protection switchover SEP ERPS (G.8032) BFD for OSPF, BFD for IS-IS, BFD for VRRP, and BFD for PIM STP (IEEE 802.1d), RSTP (IEEE 802.1w), and MSTP (IEEE 802.1s) BPDU protection, root protection, and loop protection MPLS MPLS L3VPN MPLS L2VPN (VPWS/VPLS) MPLS-TE MPLS QoS IP Routing Static routes, RIP v1/2, RIPng, OSPF, OSPFv3, IS-IS, IS-ISv6, BGP, BGP4+, ECMP, and routing policy Interoperability VLAN-Based Spanning Tree (VBST), working with PVST, PVST+, and RPVST Link-type Negotiation Protocol (LNP), similar to DTP VLAN Central Management Protocol (VCMP), similar to VTP IPv6 Features Neighbor Discover (ND) PMTU IPv6 Ping, IPv6 Tracert, and IPv6 Telnet ACLs based on source IPv6 addresses, destination IPv6 addresses, Layer 4 ports, or protocol types Multicast Listener Discovery snooping (MLDv1/v2) IPv6 addresses configured for sub-interfaces, VRRP6, DHCPv6, and L3VPN Multicast IGMP v1/v2/v3 snooping and IGMP fast leave Multicast forwarding in a VLAN and multicast replication between VLANs Multicast load balancing among member ports of a trunk Controllable multicast Port-based multicast traffic statistics IGMP v1/v2/v3, PIM-SM, PIM-DM, and PIM-SSM MSDP MVPN QoS/ACL Rate limitation in the inbound and outbound directions of a port Packet redirection Port-based traffic policing and two-rate three-color CAR Eight queues on each port DRR, SP, and DRR + SP queue scheduling algorithms WRED Re-marking of the 802.1p and DSCP fields of packets Packet filtering at Layer 2 to Layer 4, filtering out invalid frames based on the source MAC address, destination MAC address, source IP address, destination IP address, TCP/UDP port number, protocol type, and VLAN ID Queue-based rate limitation and shaping on ports Security Hierarchical user management and password protection DoS attack defense, ARP attack defense, and ICMP attack defense Binding of the IP address, MAC address, port number, and VLAN ID Port isolation, port security, and sticky MAC MAC Forced Forwarding (MFF) Blackhole MAC address entries Limit on the number of learned MAC addresses IEEE 802.1x authentication and limit on the number of users on a port AAA authentication, RADIUS authentication, and HWTACACS authentication NAC SSH V2.0 HTTPS CPU protection Blacklist and whitelist Attack source tracing and punishment for IPv6 packets such as ND, DHCPv6, and MLD packets Secure Boot IPSec ECA Deception Reliability LACP E-trunk Ethernet OAM (IEEE 802.3ah and IEEE 802.1ag) ITU-Y.1731 DLDP LLDP BFD for BGP, BFD for IS-IS, BFD for OSPF, and BFD for static route VXLAN VXLAN L2 and L3 gateways Centralized and distributed gateway BGP-EVPN Configured through the NETCONF protocol Super Virtual Fabric (SVF) The S5730-HI can work as the parent node to vertically virtualize downlink switches and APs as one device for management A two-layer client architecture is supported IGMP snooping can be enabled on Access Switches (ASs) and the maximum number of access users on a port can be configured ASs can be independently configured. Services that are not supported by templates can be configured on the parent Third-party devices are allowed between SVF parent and clients iPCA Directly coloring service packets to collect real-time statistics on the number of lost packets and packet loss ratio Collection of statistics on the number of lost packets and packet loss ratio at network and device levels TWAMP Two-way IP link performance measurement Measurement on two-way packet delay, one-way packet loss rate, and one-way packet jitter Management and Maintenance iStack Virtual cable test SNMP v1/v2c/v3 RMON Web-based NMS System logs and alarms of different levels GVRP MUX VLAN 802.3az Energy Efficient Ethernet (EEE) NetStream Intelligent OM Related products AIR-AP18321I-H-K9 AIR-AP18521-E-K9 AIR-AP2802I-H-K9 AIR-AP-3802I-E-K9 AIR-CAP1602I-C-K9 AIR-CAP2701I-E-K9 AIR-CAP3602I-C-K9 AIR-CT2504-15-K9 AIR-CT5508-25-K9 AP5030DN AP7030DN AP8030DN AP8130DN AP6010SN-GN AP2050DN-S AP6510DN-ASG AP2010DN AP6010-DN
