Huawei OptiX OSN 500 Opitcal Transmission Equipment 3 slots FE/GE Ethernet Interface Huawei OptiX OSN 500 Overview The Huawei OptiX OSN 500 is a new-generation opitcal transmission equipment used at the access layer for leased line and mobile BTS access. Huawei OptiX OSN 500 Specification Huawei OptiX OSN 500 Specification Dimensions 44mm (H) x 442mm (W) x 220mm (D) Switch capacity Packet: 7.2 Gbit/s and TDM: 21.25 Gbit/s (higher order), 5 Gbit/s (lower order) Service slots 3 slots Supported interfaces Ethernet interface FE/GE SDH interface STM-1/4 PDH interface E1/E3, T1/T3 CES interface ATM/IMA E1, ch STM-1 Networking Mode Supporting pure packet or SDH networking Supporting single-fiber bidirectional transmission Power Supply P48V DC/ -60V DC, 220V AC/110V AC Operation Environment Temperature Long term: -5C ~ 45C Short term: -5C ~ 55C Relative Humidity Long term: 5% ~ 85% Short term: 5% ~ 95% Ethernet Feature E-Line, E-LAN and QinQ MPLS-TP based VPWS and VPLS MS-PW ETH PWE3 IGMP Snooping v2 Blacklist, Broadcast packet suppression, ACL QoS Hierarchical QoS scheduling and traffic shaping DiffServ mode based on traffic classification Simple traffic classification, complex traffic classification, per hop behavior (PHB), and ACL Committed access rate (CAR) PQ scheduling priority, weighted round robin (WRR) and PQ+WRR queuing Tail drop and weighted random early detection (WRED) Shaping based on port scheduling priority OAM MPLS-TP OAM LSP/PW OAM: CC, LB, LT AIS, RDI LM, DM LCK, TST CSF Ethernet OAM ETH-CC, ETH-Loopback, ETH-Link Trace, Remote Loopback, Remote Fault Detection, RMON(RFC 2819) Protection Equipment-level Protection power 1+1 backup MPLS-TP based networklevel Protection LSP/PW Linear protection, Ring protection Anti multifailure protection based on MS-PW LAG, MC-LAG, Dual-homing protection, LPT ERPS, MSTP SDH based network-level Protection 2 fiber MS-SP Ring 1+1/1:n (nlt,=5) Linear MSP,SNCP LAG, LPT, LCAS Synchronization Both Ethernet and SDH networks supporting clock synchronization Supporting G.813, Synchronous Ethernet and IEEE 1588v2 synchronization Adaptive clock recovery (ACR) One external clock inputs/outputs (2 MHz or 2 Mbit/s) Two external time signals(1pps+TOD) Related products S5700-28P-LI-AC S5700-26X-SI-12S-AC S5700-10P-PWR-LI-AC S5700-10P-LI-AC S5700-28C-EI-AC S5700-48TP-PWR-SI-AC S6700-24-EI S6700-48-EI S6720-32C-SI-AC S6720-16X-LI-16S-AC S6720-26Q-SI-24S-AC S6720S-16X-LI-16S-AC
