2960 SFP Module SPA-1XCHSTM1/OC3 1-Port Channelized STM-1/OC-3 to DS-0 Cisco SPA-1XCHSTM1/OC3 Specification: SPA-1XCHSTM1/OC3 Specifications Product compatibility middot, Cisco 7600 Series Routers middot, Cisco ASR 1000 Series Routers middot, Cisco ASR 9000 Series Routers Minimum software version middot, Cisco 7600 Series Routers: Cisco IOS Software Release 15.4(2)S and Cisco IOS XE Software Release 3.12.0.0S middot, Cisco ASR 1000 Series Routers with Cisco IOS XE Software Releases 3.12.0,3.11.2, and 3.10.3 middot, Cisco ASR 9000 Series Routers with Cisco IOS XR Software Release 5.2.0 Protocols Serial encapsulations: middot, High-Level Data Link Control (HDLC) middot, Point-to-Point Protocol (PPP), RFC 1662 middot, Frame Relay, RFC 1490 Multilink support (bundle limit dependent on number of links per bundle, maximum of 12 links per bundle): middot, Multilink PPP (MLPPP), RFC 1990 middot, Link fragmentation and interleaving (LFI) over Frame Relay (FRF.12) and MLPPP Networking protocols: middot, IPv4/IPv6 Cards, ports, and slots 1 port Connectivity OC-3/STM-1 Small Form-Factor Pluggable (SFP) optics module (refer to optical parameters in Table 2) Features and functions Up to 84 T1 (or 3 T3) or 63 E1 (or 3 E3) ports Up to 1022 n x DS-0 channels (where n is 1 to 24) with no T3 ports configured Up to 400 n x DS-0 channels (where n is 1 to 24) with one or more T3 ports configured Support for Channelized OC-3 to T1, Channelized STM-1 to E1, clear channel T3/E3, subrate T3/E3, full-rate T1, clear channel E1, and Channelized T1/E1 SONET multiplexing: middot, OC-3 lt,-gt, STS-3 lt,-gt, STS-1 lt,-gt, VTG lt,-gt, VT1.5 lt,-gt, T1 lt,-gt, N x DS-0 middot, OC-3 lt,-gt, STS-3 lt,-gt, STS-1 lt,-gt, T3 lt,-gt, T1 lt,-gt, N x DS-0 middot, OC-3 lt,-gt, STS-3 lt,-gt, STS-1 lt,-gt, T3 middot, OC-3 lt,-gt, STS-3 lt,-gt, STS-1 lt,-gt, T3 lt,-gt, E1 lt,-gt, n x DS-0 SDH multiplexing: middot, STM-1 lt,-gt, AUG lt,-gt, AU-4 lt,-gt, VC-4 lt,-gt, TUG-3 lt,-gt, TUG-2 lt,-gt, TU-12 lt,-gt, VC-12 lt,-gt, E1 lt,-gt, n x DS-0 middot, STM-1 lt,-gt, AUG lt,-gt, AU-4 lt,-gt, VC-4 lt,-gt, TUG-3 lt,-gt, TU-3 lt,-gt, VC-3 lt,-gt, T3/E3 middot, Internal or line-derived (loop) clocking, independently selectable on each T1 or E1 tributary Loopback capabilities: middot, Local and remote loopback at the T3/T1 level middot, Network loopback at the STM-1/OC-3, T3/E3, and T1/E1 levels middot, Response to embedded loopback commands middot, Insertion of loopback commands into transmitted signal middot, Bit error rate testing (BERT) pattern generation and detection per channel middot, Programmable pseudorandom pattern up to 32 bits in length middot, T3/E3: All 0s, all 1s, 215, 220, 220 QRSS, 223, alternating 0s and 1s, 1-in-8, and 3-in-24 middot, T1/E1: All 0s, all 1s, 211, 215, 220, 220 QRSS, 223, alternating 0s and 1s, 1-in-8, and 3-in-24 middot, 32-bit error-count and bit-count registers middot, Detection of test patterns with bit error rates up to 10-2 middot, 24-hour history maintained for error statistics and failure counts, at 15-minute intervals middot, 16- and 32-bit cyclic redundancy check (CRC), 16-bit default SONET/SDH-specific features: middot, Compliance with G.707, G.783, G.784, G.957, G.958, and GR-253 middot, Supported SONET/SDH alarm and signal events: в—¦ Signal failure bit error rate (SF-BER) в—¦ Signal degrade bit error rate (SD-BER) в—¦ Signal label payload construction (C2) в—¦ Path trace byte (J1) middot, Section в—¦ Loss of signal (LoS) в—¦ Loss of frame (LoF) в—¦ Error counts for B1 Line middot, Line alarm indication signal (LAIS) middot, Line remote defect indication (LRDI) middot, Line remote error indication (LREI) middot, Error counts for B2 Path middot, Path alarm indication signal (PAIS) middot, Path remote defect indication (PRDI) middot, Path remote error indication (PREI) middot, Error counts for B3 middot, Loss of pointer (LOP) middot, New pointer events (NEWPTR) middot, Positive stuffing event (PSE) middot, Negative stuffing event (NSE) middot, Path unequipped indication signal (PUNEQ) middot, Path payload mismatch indication signal (PPLM) T3-specific features: middot, Channelized T3 with 28 DS-1 lines or 21 E1 lines multiplexed into a T3 middot, Unchannelized T3 supporting subrate and scrambling formats for Digital Link, ADC/Kentrox, Larscom, Adtran, and Verilink data service units (DSUs) middot, C-bit or M23/M13 framing middot, Maintenance data link (MDL) middot, T3 far-end alarm and control (FEAC) channel support middot, Alarm monitoring middot, Alarm indication signal (AIS) middot, Out of frame (OOF) middot, Far-end receive failure (FERF) middot, Performance data collection: в—¦ Framing bit errors (FERR) (F- or M-bit errors) в—¦ P-bit error counts (path-parity errors) в—¦ C-bit error counts в—¦ Far-end block error (FEBE) counts E3-specific features: middot, G.751 framing middot, Alarm monitoring middot, AIS middot, OOF middot, FERF middot, Performance data collection: в—¦ Framing pattern errors в—¦ BIP-8 error counts (path-parity errors) в—¦ FEBE counts middot, T1-specific features: в—¦ D4 Super Frame (SF) or Extended Super Frame (ESF) framing в—¦ ANSI T1.403 and ATT TR 54016 Facility Data Link (FDL) support в—¦ Alarm monitoring в—¦ AIS в—¦ OOF в—¦ Far-end alarm failure (yellow or distant alarm) Performance data collection: middot, CRC/bit errors middot, Framing bit errors middot, Line errored seconds middot, Far-end errored seconds middot, Far-end severely errored seconds middot, Far-end unavailable seconds E1-specific features: middot, CRC4 or non-CRC4 framing in conformance with ITU-T G.703 and G.704 middot, Alarm monitoring middot, AIS middot, OOF middot, Remote alarm indication (RAI) middot, Performance data collection middot, CRC/bit errors middot, Framing bit errors middot, FEBE Reliability and availability OIR Field-replaceable SFP optics modules Support for both 1 + 1 SONET Automatic Protection Switching (APS) and SDH Linear Multiplexer Section Protection (MSP) protocols Single SPA software reset MIBs RFC 2558 MIB (SONET/SDH) RFC 2495 MIB (T1/E1) RFC 2496 MIB (T3/E3) Network management Simple Network Management Protocol (SNMP) Physical specifications Weight: 0.75 lb (0.34 kg) Height: 0.8 in. (2.03 cm) Width: 6.75 in. (17.15 cm) Depth: 7.28 in. (18.49 cm) Regulatory compliance CE marking Safety: UL/CSA/IEC/EN 60950-1, IEC/EN 60825 Laser Safety, AS/NZS 60950, FDA Code of Federal Regulations Laser Safety EMC: FCC Part 15 Class A, ICES 003 Class A, AS/NZS 3548 Class A, CISPR 22 Class B (up to 1GHz), EN55022 Class B (up to 1GHz), VCCI Class A, BSMI Class A, EN 300 386 Telecommunications Network Equipment (EMC), EN50082-1/EN61000-6-1 Generic Immunity Standard, EN55022 Information Technology Equipment (Emissions), EN55024 Information Technology Equipment (Immunity), IEC/EN61000-3-2 Power Line Harmonics, IEC/EN61000-3-3 Voltage Fluctuations and Flicker, IEC/EN61000-4-2 Electrostatic Discharge Immunity (8kV contact, 15kV air), IEC/EN61000-4-3 Radiated Immunity (10V/m), IEC/EN61000-4-4 Electrical Fast Transient Immunity (2kV power, 1kV signal), IEC/EN61000-4-5 Surge AC Port (4kV CM, 2kV DM), IEC/EN61000-4-5 Surge Signal Port (1kV), IEC/EN61000-4-5 Surge DC Port (1kV), IEC/EN61000-4-6 Immunity to Conducted Disturbances (10Vrms), IEC/EN61000-4-8 Power Frequency Magnetic Field Immunity (30A/m), IEC/EN61000-4-11 Voltage Dips, Short Interruptions, and Voltage Variations, GR-1089-CORE NEBS EMC and Safety, GR-63-CORE NEBS Physical Protection, SR-3580 NEBS Criteria Levels (Level 3) Telecom (OC3): GR-253 Telecom (STM-1): G.783, G.957 Environmental Specifications Operating temperature: 41 to 104F (5 to 40C) Storage temperature: -38 to 150F (-40 to 70C) Operating humidity: 5 to 85% relative humidity Storage humidity: 5 to 95% relative humidity Ordering infomation: HWIC-1DSU-T1 1-Port T1/Fractional T1 DSU/CSU WAN Interface Card HWIC-1DSU-T1= 1-Port T1/Fractional T1 DSU/CSU WAN Interface Card HWIC-1T 1-Port Serial WAN Interface Card HWIC-1T= 1-Port Serial WAN Interface Card HWIC-2A/S 2-Port Async/Sync Serial WAN Interface Card HWIC-2A/S= 2-Port Async/Sync Serial WAN Interface Card HWIC-2T 2-Port Serial WAN Interface Card HWIC-2T= 2-Port Serial WAN Interface Card HWIC-1FE 1-port 10/100 Routed Port HWIC HWIC-1FE= 1-port 10/100 Routed Port HWIC HWIC-2FE Two 10/100 routed port HWIC HWIC-2FE= Two 10/100 routed port HWIC HWIC-2SHDSL 2-pair G.SHDSL HWIC HWIC-2SHDSL= 2-pair G.SHDSL HWIC HWIC-1CE1T1-PRI 1 port channelized T1/E1 and PRI HWIC (data only) HWIC-2CE1T1-PRI 2 port channelized T1/E1, and PRI HWIC (data only) HWIC-4T1/E1 4 port clear channel T1/E1 HWIC HWIC-1CE1T1-PRI= 1 port channelized T1/E1 and PRI HWIC (data only) HWIC-2CE1T1-PRI= 2 port channelized T1/E1 and PRI HWIC (data only) HWIC-4T1/E1= 4 port clear channel T1/E1 HWIC
