Cisco SPA Card SPA-1X10GE-L-V2 1-Port 10 Gigabit Ethernet Shared Port Adapter SPA-1X10GE-L-V2 Overview The Cisco SPA-1X10GE-L-V2 is available on high-end Cisco routing platforms, offering the benefits of network scalability with lower initial costs and ease of upgrades. The Cisco SPA portfolio continues the companys focus on investment protection along with consistent feature support, broad interface availability, and the latest technology. The Cisco SPA portfolio allows deployment of different interfaces (packet over SONET/SDH [POS], ATM, Ethernet, etc.) on the same interface processor. SPA-1X10GE-L-V2 Specification SPA-1X10GE-L-V2 Specifications Product Compatibility Cisco Catalyst 6500 Series Switches Cisco 7600 Series Routers Cisco 12000 Series Routers Cisco XR 12000 Series Routers Cisco ASR 1000 Series Router Cisco CRS Carrier Routing System Cisco 10000 Series Router Port Density per SPA One 10 Gigabit Ethernet port Physical Interface 10-Gbps XFP optics LED Indicators SPA status-Bicolor green and amber LEDs encode the SPA status as follows: LED off-SPA is powered off LED amber-SPA is powered on and initializing LED green-SPA is powered on and operational In addition to the status LED, the SPAs also have a bicolor LED dedicated to each port to indicate port status. The green and amber LEDs encode the port status as follows: LED off-Port is not activated by software LED amber-Port is activated by software, but there is a problem with the Ethernet link LED green-Port is activated by software, and there is a valid Ethernet link Features and Functions Full-duplex operation 802.1Q VLAN termination 802.1ad QinQ termination (stacked VLAN processing) Jumbo frames support (9188 bytes) Support for command-line interface (CLI)-controlled online insertion and removal (OIR) 802.3x flow control Bridge protocol data unit (BPDU), Cisco Discovery Protocoland VLAN Trunking Protocol (VTP) filtering Layer 2 Protocol (BPDU, Cisco Discovery Protocol, and VTP) Tunneling Layer 2 access list (MAC address-based filtering) Up to 8000 VLANs per SPA and subject to a limit of 4000 VLANs per port for 802.1q Up to 5000 MAC accounting entries per SPA (source MAC accounting on the ingress, and destination MAC accounting on the egress) Up to 2000 MAC address entries for destination MAC address filtering per SPA, and up to 1000 MAC address filtering entries per port Per-port byte and packet counters for policy drops, oversubscription drops, cyclic-redundancy-check (CRC) error drops, packet sizes, and unicast, multicast, and broadcast packets Per-VLAN byte and packet counters for policy drops, oversubscription drops, and unicast, multicast, and broadcast packets Per-port byte counters for good bytes and dropped bytes Other software features supported: Ethernet over Multiprotocol Label Switching (EoMPLS) QoS Hot Standby Router Protocol (HSRP) Virtual Router Redundancy Protocol (VRRP) Reliability and Availability OIR of the SPA within the SIP and the optics within the SPA Network Management Network management: Field-replaceable XFP modules Host-system CLI Simple Network Management Protocol (SNMP) Inventory- and asset management-related MIBs: Entity-MIB (RFC 2737) Cisco-entity-asset-MIB Fault management: Cisco-entity-field-replaceable unit (FRU)-control-MIB Cisco-entity-alarm-MIB Cisco-entity-sensor-MIB Physical interface management: IF-MIB Etherlike-MIB (RFC 2665) Other MIBs: Remote Monitoring (RMON)-MIB (RFC 1757) Cisco-class-based-QoS-MIB MPLS-related MIBs Ethernet MIB/RMON Physical Specifications Weight: 0.75 lb (0.34 kg) Height: 0.8 in. (2.03 cm) (single height) Width: 6.75 in. (17.15 cm) Depth: 7.28 in. (18.49 cm) Power 19.9W Environmental Specifications Storage temperature: -38 to 150F (-40 to 70C) Operating temperature, nominal: 32 to 104F (0 to 40C) Operating temperature, short term: 32 to 131F (0 to 55C) Storage relative humidity: 5 to 95% relative humidity Operating humidity, nominal: 5 to 85% relative humidity Operating humidity, short term: 5 to 90% relative humidity Operating altitude: -60 to 4000 meters Compliance and Agency Approvals Safety UL 60950-1 CSA C22 No. 60950-1 EN 60950-1 IEC 60950-1 AS/NZS 60950 EN 60825-1 EN 60825-2 21 CRF 1040 EMC CFR 47, FCC Part 15-Class A ICES 003-Class A CISPR 22 Class A EN 55022 Class A EN 300386 Class A AS/NZS Class A VCCI-Class B EN 50082-1 EN 55024 IEC/EN61000-4-2 Electrostatic Discharge Immunity (8-kV contact, 15-kV air) IEC/EN61000-4-3 Radiated Immunity (10 V/m) IEC/EN61000-4-4 Electrical Fast Transient Immunity (2-kV power, 1-kV signal) IEC/EN61000-4-5 Surge AC Port (4-kV CM, 2-kV DM) IEC/EN61000-4-5 Surge Signal Port (1-kV indoor, 2-kV outdoor) IEC/EN61000-4-5 Surge DC Port (1 kV) IEC/EN61000-4-6 Immunity to Conducted Disturbances (10 Vrms) IEC/EN61000-4-8 Power Frequency Magnetic Field Immunity (30 A/m) IEC/EN61000-4-11 Voltage Dips, Short Interruptions, and Voltage Variations Telecom IEEE 802.3ae (10 Gigabit Ethernet interface SPA) Industry Standards The Cisco 1-Port 10-GE SPA is designed to meet the following requirements (some qualifications are currently in progress): SR-3580-Network Equipment Building Standards (NEBS): Criteria levels (Level 3 compliant) GR-63-CORE-NEBS: Physical protection GR-1089-CORE-NEBS EMC and safety The Cisco Interface Flexibility (I-Flex) design combines shared port adapters (SPAs) and SPA interface processors (SIPs), taking advantage of an extensible design that facilitates service prioritization for voice, video, and data services. Enterprise and service provider customers can take advantage of improved slot economics resulting from modular port adapters that are interchangeable across Cisco Systems routing platforms. The Cisco I-Flex design maximizes connectivity options and offers superior service intelligence through programmable interface processors that deliver line-rate performance. Cisco I-Flex enhances speed-to-service revenue and provides a rich set of quality-of-service (QoS) features for premium service delivery while effectively reducing the overall cost of ownership. This data sheet contains the specifications for the Cisco 1-Port 10 Gigabit Ethernet Shared Port Adapter, Version 2 (Cisco 1-Port 10-GE SPA, Figure 1 shows a SIP with 10 Gigabit Small Form-Factor Pluggable [XFP] optics) Business
